Tuesday 28 December 2021

Ccnp Tshoot Chapter 9 Exam Answers


Found 1443 results for: Ccnp Tshoot Chapter 9 Exam Answers


[FREE] Ccnp Tshoot Chapter 9 Exam Answers | HOT

Hello packets are not sent from either neighbor. Slow network connections cause OSPF advertisements to time out. The network command has put the connected interfaces into the same OSPF area. Question 33 Question Refer to the exhibit. A port channel...

Found: 24 May 2021 | Rating: 92/100

[DOWNLOAD] Ccnp Tshoot Chapter 9 Exam Answers | latest

The main site has been configured to bundle links into an EtherChannel and the branch site has not. The branch site is running a newer, incompatible version of the Spanning Tree Protocol. The main site has inconsistencies in the physical ports that...

Found: 24 May 2021 | Rating: 91/100


Tshoot Chapter 9 CCNP 6

However, both routers never transition beyond 2WAY state. What is the cause of this problem? Authentication is enabled on only one side. There is a switch problem and multicast capabilities are broken. A network administrator is unable to have two BGP peers exchange routing information. Which solution would correct this problem? Router R1 should be configured with the neighbor 2. The loopback interfaces on each router should be removed. What is a possible cause of this problem? There is a mismatched interface MTU. An access list is blocking OSPF hellos. Duplicate Router IDs are configured on the new router. Layer 2 switches between the two routers are not multicast aware. A network administrator issued the show ip cef command to verify the routing operations on the device. Which table entries will be present in the output? Based on the shown output, what is the resulting effect on the routing table? A route to the network What can be determined about the origin of the route to the The route is manually entered.

Found: 5 Apr 2021 | Rating: 89/100

CCNP TSHOOT 642-832 Official Certification Guide

The route is directly connected to RouterHQ2. When viewing the routing table, the administrator notices that the entries for the remote networks are not listed. Automatic summarization must be disabled. EIGRP is not enabled on the correct interface. An incorrect keychain name has been entered under the serial interface. What is the result of issuing the ip route profile command on a router? The router will log each route redistribution entry to the configured syslog server. The router will track the number of routing table changes that occur over 5 second sampling intervals. The router will send console messages each time a route is installed or removed from the routing table. Until the buffer is full, the router will archive a copy of the routing table each time the topology changes.

Found: 12 Apr 2021 | Rating: 87/100

CCNPv7 Tshoot Chapter 6 Answers

Examine collected information Answer: B Q7. What are the two primary goals of troubleshooters as they are collecting information? Choose two answers. Eliminate potential causes from consideration. Identify indicators pointing to the underlying cause of the problem. Hypothesize the most likely cause for a problem. Find evidence that can be used to eliminate potential causes. Answer: B and D Q8. When performing the eliminate potential causes troubleshooting step, which caution should the troubleshooter be aware of?

Found: 6 Apr 2021 | Rating: 88/100

CCNP TSHOOT FAQ: Introduction To Troubleshooting Processes

The danger of drawing an invalid conclusion from the observed data b. The danger of troubleshooting a network component over which the troubleshooter does not have authority c. The danger of causing disruptions in workflow by implementing the proposed solution d. The danger of creating a new problem by implementing the proposed solution Answer: A Q9. A troubleshooter is hypothesizing a cause for an urgent problem, and her hypothesis involves a network device that she is not authorized to configure.

Found: 19 Apr 2021 | Rating: 89/100

Ccnp Switch Chapter 9 Exam Answers

The person who is authorized to configure the network device is unavailable. What should the troubleshooter do? Wait for authorized personnel to address the issue. Attempt to find a temporary workaround for the issue. Override corporate policy, based on the urgency, and configure the network device independently because authorized personnel are not currently available. Instruct the user to report the problem to the proper department that is authorized to resolve the issue.

Found: 22 Apr 2021 | Rating: 86/100

Chapter 8 Exam - Ccnp-Tshoot Sp2021

Answer: B Q What are two reasons why troubleshooters should document their steps as they attempt to verify their hypothesis? Choose the two best answers. The steps can be submitted to the proper authority prior to their implementation. The steps serve as a rollback plan if the attempted solution does not resolve the problem. The steps help ensure the troubleshooters do not skip a step in their solution. The steps help reduce duplication of efforts. Answer: B and C Q What two steps should be taken after a problem has been resolved? For consistency, the same configuration should be implemented on all equipment of the same type.

Found: 4 Apr 2021 | Rating: 92/100

Cisco Chapter 7 Assessment Answers

To accidentally prevent their reuse, previously archived configurations of the repaired device should be deleted from the archive server. Confirm that the user who reported the problem agrees that the problem is resolved. Answer: C and D Q What is the ideal relationship between network maintenance and troubleshooting? Networking maintenance and troubleshooting efforts should be isolated from one another.

Found: 22 Apr 2021 | Rating: 90/100

Ccna Index Of

Networking maintenance and troubleshooting efforts should complement one another. Networking maintenance and troubleshooting efforts should be conducted by different personnel. Networking maintenance is a subset of network troubleshooting. Which three of the following suggestions can best help troubleshooters keep in mind the need to document their steps? Choose three. Require documentation. Routinely back up documentation. Schedule documentation checks. Answer: A, C, and D Q

Found: 28 Apr 2021 | Rating: 93/100

CCNP Switch V7.1 Chapter 9 Exam Answer

What is the first step of a structured troubleshooting process? Refer to the exhibit. What principles are depicted in the exhibit? Which element forms the basis of a good problem description?

Found: 11 Apr 2021 | Rating: 92/100

CCNA Security V2.0 Chapter 9 Exam Answers

What is the reason for this traffic behavior? EIGRP does not loadbalance automatically over equal-cost paths. A network technician has just configured router East to establish a tunnel to router West. After the configuration is applied, tunnel 1 is flapping. What needs to be done to stop this flapping? Change the configuration on router East such that the destination of tunnel 1 is A new system administrator is unable to obtain access to the EXEC shell. Based on the exhibited output of the debug aaa authorization command, what is the reason the administrator is unable to access the shell? The command has not been properly configured to require authorization. A network administrator is attempting to connect a branch office to headquarters through a VPN tunnel. The tunnel is reported as being active at both ends, but the The administrator has determined that the problem is with the branch office configuration.

Found: 18 Apr 2021 | Rating: 88/100

Tshoot Chapter 9 Ccnp 6

Based on the output as shown, why is the The tunnel destination end point has been improperly configured. The tunnel encapsulation is improperly configured. The tunnel protocol is improperly set. A network administrator has recently implemented a GRE tunnel between the HQ router and a branch site. Whenever the GRE tunnel is activated, the indicated console messages are generated. Which two actions could fix this problem? Choose two. Change the network routing protocol to OSPF. On both the HQ and branch routers, enter static routes to the tunnel destination that will be preferred over the one through the tunnel. Which statement about the debug radius authentication output is correct? The user raduser is on a device with the IP address of The user raduser has been authenticated. A legitimate user experienced a problem while attempting to gain access to the router EXEC shell. To investigate the situation, a network administrator issued debug tacacs and debug aaa authentication commands on the router.

Found: 7 Apr 2021 | Rating: 93/100

CCNPv7 - Chapter 3 Exam - Advanced Routing

Based on the provided output, what could be the problem? Based on the debug aaa authentication and debug tacacs outputs, which statement is true? The attempt of a remote user with the IP address The authentication process verifies the user credentials to the local database. The user with the IP address Based on the provided debug aaa authorization and debug tacacs command output, which statement is true? The AAA security server authorized the user Admin to perform the requested command.

Found: 10 Apr 2021 | Rating: 89/100

CCNP TShoot Final

Upon examination of the log files, the administrator observed the following message. The switch was not able to create the EtherChannel link. Only one switch is properly configured for EtherChannel. There is an uneven distribution of traffic on the EtherChannel bundle members. It carries traffic for multiple VLANs. It is a physical interface in a single VLAN. It is created when the associated VLAN is created.

Found: 13 Apr 2021 | Rating: 87/100

Chapter 8 Exam - Ccnp-Tshoot Sp | Router (Computing) | Routing

We use this information to address the inquiry and respond to the question. We use this information to complete transactions, fulfill orders, communicate with individuals placing orders or visiting the online store, and for related purposes. Surveys Pearson may offer opportunities to provide feedback or participate in surveys, including surveys evaluating Pearson products, services or sites.

Found: 16 Apr 2021 | Rating: 90/100

CCNP TSHOOT FAQ: Introduction To Troubleshooting Processes - Config Router

Participation is voluntary. Pearson collects information requested in the survey questions and uses the information to evaluate, support, maintain and improve products, services or sites; develop new products and services; conduct educational research; and for other purposes specified in the survey. Contests and Drawings Occasionally, we may sponsor a contest or drawing. Participation is optional. Pearson collects name, contact information and other information specified on the entry form for the contest or drawing to conduct the contest or drawing. Pearson may collect additional personal information from the winners of a contest or drawing in order to award the prize and for tax reporting purposes, as required by law. Newsletters If you have elected to receive email newsletters or promotional mailings and special offers but want to unsubscribe, simply email information ciscopress. Service Announcements On rare occasions it is necessary to send out a strictly service related announcement.

Found: 19 Apr 2021 | Rating: 89/100

Ccnp Switch Chapter 9 Exam Answers-PassHot

Other Collection and Use of Information Application and System Logs Pearson automatically collects log data to help ensure the delivery, availability and security of this site. We use this information for support purposes and to monitor the health of the site, identify problems, improve service, detect unauthorized access and fraudulent activity, prevent and respond to security incidents and appropriately scale computing resources.

Found: 26 Apr 2021 | Rating: 92/100

Final Exam CCNP ROUTE 2021

Web Analytics Pearson may use third party web trend analytical services, including Google Analytics, to collect visitor information, such as IP addresses, browser types, referring pages, pages visited and time spent on a particular site. While these analytical services collect and report information on an anonymous basis, they may use cookies to gather web trend information. The information gathered may enable Pearson but not the third party web trend services to link information with application and system log data. Pearson uses this information for system administration and to identify problems, improve service, detect unauthorized access and fraudulent activity, prevent and respond to security incidents, appropriately scale computing resources and otherwise support and deliver this site and its services.

Found: 14 Apr 2021 | Rating: 93/100

No comments:

Post a Comment

Woodworking Safety Test Answers

Found 2531 results for: Woodworking Safety Test Answers [GET] Woodworking Safety Test Answers | latest! Wear protective footwear when requ...